Category: How-To

A step-by-step method for cutting oak, maple and walnut with a jigsaw: blade TPI, speed dial, orbital setting, support and the mistakes that cause burning and bevel drift.

A step-by-step method for cutting plywood with a jigsaw: blade choice, orbit setting, scored and taped lines, full support underneath, and how to trim the edge to your finished line.

A step-by-step guide to setting up and using a miter saw for cutting crown molding, including exact angle settings, coping, and common mistakes.

A step-by-step guide to dialing in a miter saw for trim work, from squaring the blade to coping inside corners and hiding gaps on crooked walls.

A step-by-step guide to cutting plywood with a circular saw: tooth count, blade depth, shoe offset, clamped guides and the setup that stops splintering.

Almost any saw cuts a 2×4, but square, splinter-free results come down to depth setting, tooth count, and how you support the board. Here is the full procedure.

A step-by-step method for squaring rough lumber to four flat, square faces using only a planer, table saw and a hand plane or two.

A practical wood glue guide that walks through choosing the right adhesive, prepping surfaces, clamping correctly, and diagnosing joints that fail.

A step-by-step guide to pocket hole joinery, including jig settings, screw lengths, driving torque, and the joints where pocket screws should never carry the load.

Kickback is the table saw’s real danger, and it is preventable: here is the setup and cutting routine that keeps wood from ever touching the back of the blade.